EMART EM-LS703-2, two stands, 87 to 210 cm, 1 kg each
Two stands for 37 €, each reaching 210 cm and carrying 5 kg at 1 kg apiece — and the only page here to publish both a folded length and a weight.
- Maximum and minimum height
- 87 to 210 cm, in the second bullet. At 87 cm it starts higher than the NEEWER and the Walimex, which come down to 44 cm — which matters for lighting a seated subject or a table from just above
- Folded length
- 73 cm, in the second bullet. The buying advice for this shelf says to measure the folded length against the bag you already own before anything else, and this is one of only two pages here to publish it
- Section count
- Not published. The page describes assembly in three minutes without tools and never says how many segments the column has, so the number of clamps to check is unknown
- Spigot and thread sizes
- A 1/4 inch screw thread, in the third bullet, named for standard lighting, on-camera flashes and softboxes. No 5/8 inch stud is mentioned — the studio convention the hub above describes — so this is a stand that finishes in a camera thread and suits a small flash rather than a heavy head
- Declared load
- 5 kg, in the first bullet. It is the second highest on this shelf and it sits oddly beside the 1/4 inch thread: the mount is sized for a light flash while the column is rated for a studio head
- Leg spread
- Not published. No footprint diameter appears, and the hub above warns that a softbox turns a stand into a sail — at which point the spread and the centre of gravity matter more than the load figure
- Material
- Aluminium alloy with a black finish, in the first bullet, at a net weight of 1 kg each. The fifth bullet lists what comes in the box: two stands and two carry bags
- Amazon reference
- B07Q85F8XW (same reference on 6 Amazon marketplaces)
- EAN
- 0733205101011
- Two complete stands and two bags for 37 €, where a single stand on this shelf costs 39 €
- A folded length of 73 cm and a weight of 1 kg both published
- A 1/4 inch thread only, with no 5/8 inch stud for studio fittings
Best for: A first two-light setup at home, where a flash or a small LED panel goes on each stand and both have to travel in a bag.